The XYZprinting da Vinci is a fine choice of 3D printer for a beginner or a simple enthusiast. It\u2019s quiet, produces great prints, and, most importantly, is affordable. If you don\u2019t mind that it takes a long time to print and that you can only use XYZ-provided filaments, then go for it. Check out our best 3D printer list for more!\r\n\r\n\r\nWhy We Like It - XYZ da Vinci Nano\r\nThe XYZprinting da Vinci Nano 3D pPrinter is a fantastic and affordable introduction into the world of 3D Printing. If you\u2019ve ever been curious, or just want to begin learning, the da Vinci Nano\u2019s straightforwardness and incredibly affordable price can entice anyone to at least try and give it a whirl.\r\n\r\n\r\nPerformance\r\nThe XYZ da Vinci is a quiet printer, which is nice, with the only audible noise being the whining and whirring of fans, motors, and the print head moving. You will need to have your Nano connected to your computer to have it print, but it can be disconnected once it begins printing. The print quality is clean and smooth with well-made edges, but it does take a long time to print. This is especially true with the higher-quality settings. If price is no option and you want to produce extremely high quality prints, try the Zortrax M200 3D Printer.\r\nDesign\r\nThe XYZ da Vinci Nano comes with built-in safety and convenience features such as auto-calibration, auto-feeding filament system, and a removable print bed. The PLA filament features a chip that identifies it to the printer and the Nano only works with XYZ-provided filaments. The filaments, though, come in 14 colours, so printing in full colour shouldn\u2019t be too much of a hassle. It\u2019s simple and straightforward and will take you less than 30 minutes from unboxing to first print. If you\u2019re sold on XYZprinting already but want something more high-end check out the XYZprinting Nobel 3D Printer.\r\nValue\r\nThe XYZ da Vinci Nano can only be used with filaments from XYZ, mentioned above, and these filaments cost about $28.00 each. Not terribly expensive, but it\u2019s still a little bit higher than third-party filaments. The unit itself retails for about $170 which is a fantastic price considering all the features you\u2019re getting. The modelling software included with the Nano is interesting and includes basic modeling tools to add text to existing models. If you want a great, higher-end printer that\u2019s inexpensive as far as high-end printers go, try the LulzBot Mini 3D Printer.\r\nXYZ da Vinci Nano Wrap Up\r\nYou get a lot of printer for the da Vinci Nano\u2019s $170.00 price tag. It\u2019s software is simple and offers some unique features, and the PLA filaments come in a wide variety of colours. Just remember that you\u2019ll be stuck using XYZ-provided filaments only, and that the printing speed is on the slow side. Other than that, have fun!