If you are shopping around for new wireless network devices, you may wonder how to change a router. Even the best routers, after all, become outdated after a while and must be replaced. So what is the process here for swapping out an old router for the new one? Keep reading to find out.

KEY TAKEAWAYS:

  • Swapping out a router for a new one is a relatively simple process, starting by finding a good spot for the router to rest so it can create a comprehensive wi-fi network.
  • You should always change the network name and default password upon initial setup, to discourage hackers.
  • Disabling remote access via the router settings is also a good idea, as this could easily be co-opted by hackers and other neer-do-wells.

Changing Out Routers

If you’ve purchased a new router, the replacement process is on the simple side, as modern devices are indicated to be used by amateurs and experts alike. You should simply be able to look at it to start to firm up your approach, especially when you ask how many Ethernet ports a router has.

Insider Tip

A living room makes a better spot for a router than a bedroom, as long as it can easily connect to the cable modem via analog Ethernet cable.

Basically, a router connects via Ethernet cable to your modem and then emits a wireless signal to your devices. Here are some of the things you must do to get surfing and streaming.

Set a Network Name and Password

The router’s firmware software will ask you to set a password and a network name. Be careful when doing both, making the password complex enough to deter would-be hackers. New routers tend to always feature the same network name and password out of the box, so it is extremely important to change this information as soon as possible.

Disable Remote Access

Remote access allows you to log in to your router’s settings from the Internet, even when you are not using your router’s wireless network. This could come in handy in very specific scenarios, but it is a best practice to simply disable remote access, as it could also come in handy for hackers.

Find a Good Resting Spot

Take some time to find the perfect spot for your router to rest, adjusting the antenna accordingly. This spot should be somewhere centrally located, so wireless signals can reach all of your devices. Also, make sure none of the ports are blocked, in case you need them later on. If you are wondering what are router ports and what they are used for, they allow for cabled connections.

Enable or Disable Parental Controls

Take time to enable or disable any parental control settings, depending on if you have children or not and if you want to restrict their access to the Internet. Your instruction manual should note how to access these settings.

F.A.Q.S

How to change your wireless router’s admin password?

To push the reset button on router passwords, including the admin password, direct your mobile device or laptop to a provided address bar and enter in your network name and password.


Where to find a router default password?

Modern routers typically include the default password in the instructions somewhere, or even on the wi-fi settings page.


How to activate remote management?

If you ever want to enable remote management, so you can change up Wi-Fi network settings using a mobile device, check the instructions for information. Typically, this involves using a browser’s address bar.



STAT: Your network name and password may be found on a label on your router or modem-router combo (gateway). (source)

Lawrence Bonk

Lawrence Bonk is a copywriter with a decade of experience in the tech space, with columns appearing in Engadget, Huffington Post and CBS, among others. He has a cat named Cinnamon.

Related Articles

Leave a Reply

Your email address will not be published. Required fields are marked *